![]() ![]() The help system was rewritten and upgraded to display information directly from our Wiki. Fehlermeldungen ohne Diskussion werden geschlossen. ![]() Hinweis: Nur Fehlermeldungen, die zuvor im Forum diskutiert wurden, werden berücksichtigt. Jetzt sind alle FreeCAD-Webseiten unter und zu finden.ĭie FreeCAD-Fehlerverfolgung ist nach GitHub umgezogen: Wir freuen uns darüber, dass das KiCAD-Projekt durch die KiCAD services corp. Für diese Versionshinweise wurde es mit ezgif zugeschnitten und in seiner Größe angepasst. Die animierte GIF-Grafik selbst wurde unter Verwendung von GIMP erstellt. Die Bilder für die animierte Grafik wurden mit dem FreeCAD-Makro Bildschirm Wiki erstellt. Modell eines 775 Gleichspannungsmotors von Benutzer "jimmihenry", siehe Users Showcase.ĭas Modell wurde komplett mit den wöchentlichen development snapshots von FreeCAD 0.20 erstellt. Ältere FreeCAD-Versionshinweise findet man in der Funktionsliste. Diese Seite listet alle Neuerungen und Änderungen auf. So i suppose this is a bug (partial redundant constraints causing breakage).FreeCAD 0.20 wurde am 14 Juni 2022 veröffentlicht, es kann von der Download-Seite heruntergeladen werden. However your project assumes that the arc is a half circle (you used tangency constraints at the 2 points), which isn't always the case. The project you attached is correct indeed, as is my example project with the partial redundancy removed. So this should fully constrain the arc, and as chrisb had pointed out, the issue is caused by partial constraint redundancy, and not lack of constraints. The whole arc is created as external geometry in the 2nd sketch, and the normal arc is created using the external center and 2 points. The arc in the master sketch is defined through center + 2 points (a center with 2 points define exactly an arc, actually 2 complementary arcs). You need here to refer to the center and one end of the 1st arc. You cannot copy an arc with 3 points : an arc is 5 Degrees of Freedom (dof) and 3 points are 6 dof. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |